To setting up extender people access the WiFi Wavlink com login page. But after the Wavlink wireless range extender setup, you may see numerous light flashes on the extender. Each power LED light has a different meaning. If the power LED indicates green, it means that everything is perfect. On the off chance if the LED light blinks yellow, it means your extender caught some error. If your device also shows yellow light then no need to worry. You are not alone. A lot of users around the world face this issue. To fix this issue, keep reading.
Causes: Wavlink Extender Yellow Light Issue
There are a plethora of reasons why your Wavlink range extender shows a yellow light. Some of the most basic factors are listed below:
- 1. The distance between the wireless devices is not adequate.
- 2. The internet connection is shaky.
- 3. Technical glitches.
- 4. The power cable connection is faulty or damaged.
- 5. The extender firmware is outdated.
- 6. Improperly setup extender.
- 7. WiFi Interference.
- 8. The range extender is not turned on.
Solution: Wavlink Extender Yellow Light Issue
Fixing the Wavlink range extender yellow light issue is pretty simple. Follow the steps given below in the given order to resolve the problem.
I. Restart the Extender
The first and foremost way to fix the extender’s yellow light issue is to power cycle the extender. The reason being is restarting or rebooting works like magic in fixing many technical hiccups. Underneath we discussed the instructions to reboot the wireless range extender.
- a. Firstly, detach the extender from the host router.
- b. After that power off the device and remove it from the electrical socket.
- c. Hold on for a couple of seconds.
- d. Now, put the extender back into the power source and turn on the switch.
- e. Do not forget to connect the extender and router again.
II. Check the Internet Connection
The next step in line to resolve the yellow issue is to check the WiFi connection. If everything is correct from your side then immediately contact your Internet Service Provider (ISP). To get off this issue, make sure that you have a blazing internet connection.
III. Verify Ethernet Cable
Next, you need to confirm if the Wavlink range extender is properly connected to the host router or not. Be sure that the Ethernet cable connection is secure. On the off chance, you are still stuck with the same issue, try the next hack in line.
IV. Change the Extender Location
As we discussed earlier the inappropriate position of the wireless devices is also creates a yellow light issue. To troubleshoot this issue, make sure that the WiFi extender and router are placed within the range.
V. Reset & Reconfigure the Extender
This is last but not least option that you must try when no other troubleshooting tip worked. This is to reset your Wavlink range extender to its factory default mode. If you have no idea how to reset the extender then walk through the instructions given below:
- i. First thing first, remove the connection between the WiFi router and extender.
- ii. After that, make sure that your range extender is powered on
- iii. Next, find the reset button on the extender.
- iv. Once you find it, take a sharp pointed object such as a paper clip or oil pin to press it.
- v. Now, wait for a little while.
- vi. Your extender is running on its factory default settings.
That’s it! Now, you have to perform the WiFi wavlink com setup process again after the reset process.
In the End
With that! We end our guide on how to fix the Wavlink range extender yellow light issue. We hope that with the help of the above-mentioned hacks, you can easily fix the issue in a hassle-free way. Did you like reading this article? Leave your feedback in yes or no via the comment section. Your feedback might be helpful to your fellow readers.