If you’re facing internet connection issues, slow browsing, or have forgotten your dlink router login credentials, it might be time to reset your D-Link router to its factory default settings. Resetting your router can be an effective way to start fresh and resolve various network-related problems. In this article, we’ll guide you through the easy methods to reset your D-Link router without any technical support. Keep reading!
Hard Reset
Most D-Link routers come with a physical reset button that allows you to reset the router easily. Follow these steps:
Locate the Reset Button
Look for a small, recessed button labeled “Reset” on the back or bottom of your D-Link router. It’s usually located near the Ethernet ports.
Turn On the Router
Ensure your router is powered on by connecting it to a working electrical outlet.
Press and Hold the Reset Button
Gently insert a paperclip or a pin into the reset button’s hole and hold it down for about 10-15 seconds. You should notice the router’s lights blinking during this process.
Release the Button
After holding the button for the required time, let go. Your D-Link router will automatically reboot and return to its factory default settings.
Set Up Your Router Again
Once the router restarts, you’ll need to set up your Wi-Fi network and other configurations from scratch. Refer to the router’s user manual for initial setup instructions.
That’s it, now you know the steps to set the D link router to its factory default settings. If you see this method is hard to perform, then you don’t need to worry. After all, we have one more method for you that we discuss below.
Reset D-Link Router via Soft Reset
In this procedure, you need to access the dlinkrouter.local default web address. Below we give the easy-to-follow instructions for the soft reset process:
Power on Computer
- The very first thing you need to do is power on the computer. You can also use a tablet and laptop for the same.
- Make sure your device gets a sufficient power supply from the socket.
- Use the UPS if there is a problem with a power cut.
Connect the Computer to Router’s Network
- Once the computer is boot up, you need to connect your computer to the router’s network.
- Open the network list of your device.
- Look for the SSID name D-link router.
- Click on it to connect with the network.
Open Internet Browser
- Now open the web browser on your device.
- The web browser should be updated so that you easily proceed further.
Access Default Web Address
- Typing the dlinkrouter.local web address into the URL bar of the device.
- Do not make typing errors into the URL.
- Once you type the URL cross check it.
- Press the Enter key to reach out to the D-link router login page.
Log In to Router
- Now you are at the D-link router page.
- Fill in the Admin details(Username & Password).
- Keep the caps lock key of the keyboard off.
- Click on the Log In button
Access the D-Link Router Dashboard
- The setup of the router will appear in which you see the information related to the router.
- Here you can make the changes in the settings of your device.
Reset D-Link Router
- Go to the “TOOLS” Page.
- Select the “SYSTEM” option.
- Look for the RESET option,
- Click on reset and give the confirmation.
- Click on OK and your D-link router will initiate the soft reset process.
Note: Do not disturb the soft reset process once it starts. If you interrupt the process you may face the issues after completing the reset.
Once you set your D-link extender to its factory default settings you will get your device new. So, you need to re-install it by accessing the default web address. After that, you can customize the settings of the router according to your choice.
Hence, now you know the two most easy and effective methods to reset the D-link router. You can go with any one of them according to your convenience.